|
|
|
Usuarios conectados
Actualmente hay 5962 visitantes y
2 usuarios online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Section
Audio Adjustments
06
Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Press AUDIO to select Loud. Press AUDIO until Loud appears in the display. 2 Press 5 to turn loudness on. Loudness level (e.g., Loud Mid) appears in the display. 3 Press 2 or 3 to select the level. Press 2 or 3 until the desired level appears in the display. Low (low)�Mid (mid)�High (high) 4 Press � to turn loudness off. Loud OFF appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Press AUDIO to select the Sub-W2. When the subwoofer output is on, you can select the Sub-W2. Press AUDIO until Sub-W2 80 (Hz) appears in the display. � If the subwoofer setting has been previously adjusted, the frequency of that previously selected will be displayed, such as 50 (Hz) or 125 (Hz). 2 Press 2 or 3 to select cut-off frequency. Press 2 and 50 (Hz) is displayed. Press 3 and 125 (Hz) is displayed. Only frequencies lower than those in the selected range are output from the subwoofer. 3 Press 5 or � to adjust the output level of the subwoofer. Each press of 5 or � increases or decreases the level of the subwoofer (e.g., +6 to �6). Press 5 or � until you see the desired value displayed.
Using subwoofer output
This unit is equipped with a subwoofer output which can be switched on or off. 1 Press AUDIO to select Sub-W1. When the subwoofer controller setting is S.W Control:EXT, you cannot select Sub-W1. Press AUDIO until Sub-W1 appears in the display. 2 Press 5 to turn subwoofer output on. Sub-W1 Normal appears in the display. Subwoofer output is now on. � You can turn off subwoofer output by pressing �. 3 Press 2 or 3 to select the phase of subwoofer output. Press 2 to select reverse phase and Rev. appears in the display. Press 3 to select normal phase and Normal appears in the display.
English Español Deutsch Français Italiano Nederlands
En
27
|
|
|
> |
|
