2.1.4 Removing the heat sink (See Fig.4) � Prior to performing the following procedure, remove the front panel assembly as required. (1) Remove the two screws B and two screws C attaching the heat sink on the left side of the main body, and remove the heat sink.
C
B
C
Heat sink Fig.4
2.1.5 Removing the rear bracket (See Fig.5) � Prior to performing the following procedure, remove the bottom cover. (1) Remove the three screws D, screw E and six screws F attaching the rear bracket on the back side of the main body. (2) Remove the rear bracket. Reference: During reassembly, before fixing the rear bracket onto the main body, insert the video out cable into the slot.
F
Rear bracket
F
E
F
D
D
Insert the video out cable into the slot. Fig.5
2.1.6 Removing the main board (See Fig.6) � Prior to performing the following procedure, remove the front panel assembly, front chassis assembly, heat sink, bottom cover and rear bracket. (1) Remove the two screws G attaching the main board. (2) Disconnect the connector CN501 and remove the main board.