JVC KDSH909R
Manual de Servicio

KD-SH909R Removing the trigger arm (See Fig.18 and 19)
Prior to performing the following procedure, remove the top cover, the connector board and the clamper unit. 1. Turn the trigger arm in the direction of the arrow to release the joint k and pull out upward.
Joint k

Trigger arm

CAUTION: When reassembling, insert the part l and m of the trigger arm into the part n and o at the slot of the chassis rivet assembly respectively and join the joint k at a time.

Chassis rivet assembly

Fig.18

Part n Trigger arm Part l Part m Part o

Chassis rivet assembly

Fig.19

Removing the top plate assembly (See Fig.20)
Prior to performing the following procedure, remove the top cover, the connector board, the chassis unit, and the clamper assembly. 1. Remove the screw H. 2. Move the top plate assembly in the direction of the arrow to release the two joints p.

Top plate assembly

H

Joints p

q

3. Unsolder the wire marked q if necessary.

Fig.20

1-16