JVC KD-SH55J
Manual de Usuario

To change the AM/FM channel intervals ENGLISH
� AREA
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and 200 kHz for FM (AREA US settings). You will have to change the channel intervals when using this unit in an area other than North America and South America. � AREA EU: Select this when using this unit in an area other than North and South America. (9 kHz for AM and 50 kHz (for manual tuning) / 100 � AREA US: kHz (for searching) for FM) Select this when using this unit in North or South America. (10 kHz for AM and 200 kHz for FM)

To adjust the auxiliary input level
� AUX ADJ
Adjust the auxiliary input level properly when an external component is connected to the MP3 INPUT jack. When shipped from the factory, the auxiliary input level is set at level 00. If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change the source from the external component to another source.

To select the target component to operate through this receiver
� KEY SELECT (For KD-SH77 only)
You can operate either JVC�s VCR or DVD player through this receiver, by using the number buttons on the control panel. When shipped from the factory, these number buttons are set to be used for the DVD operations. To use these number buttons on the control panel for DVD or VCR operations, see page 25.

Note: If the channel intervals settings are changed, the names assigned to the stations will be erased from memory. To reassign the names, see �Assigning names to the sources� on pages 21.

To adjust the line input level � LINE ADJ
(For KD-SH77 only)
Adjust the line input level properly when an external component is connected to the LINE IN plugs. When shipped from the factory, the line input level is set at level 00. If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change the source from the external component to another source.

To change the FM tuner selectivity
� IF FILTER
In some areas, adjacent stations may interfere with each other. If this interference occurs, noise may be heard. This unit has been preset to automatically reduce this interference noise (�AUTO�) when shipped from the factory. � AUTO: When this type of interference occurs, this unit automatically increases the tuner selectivity so that interference noise will be reduced. (But the stereo effect will also be lost.) Subject to the interference from adjacent stations, but sound quality will not be degraded and the stereo effect will not be lost.

To select the external component to use
� EXT INPUT (For KD-SH55 only)
You can connect the external component to the CD changer jack on the rear using the Line Input Adaptor KS-U57 (not supplied). To use the external component as the playback source through this unit, you need to select which component � CD changer or external component � to use. When shipped from the factory, CD changer is selected as the external component. � LINE INPUT: To use the external component other than CD changer. � CD CHANGER: To use the CD changer. � WIDE:

To turn the demo mode on or off
� DEMO MODE
You can turn the demo mode on or off. When shipped from the factory, �DEMO ON� is selected. � DEMO ON: Turns the demo mode on. The demonstration will start automatically if no sound comes in for 3 minutes. � DEMO OFF: Turns the demo mode off.

Note: For connecting the Line Input Adaptor KS-U57 and the external component, refer to the Installation/ Connection Manual (separate volume).

Note: If the unit has been reset (and the power is on), demonstration will start if no sound comes in for about 10 seconds.

20