Installation I Removing the hard rubber frame 1 Refer to the section �Theft deterrent faceplate (P. 10)� and
then remove the faceplate.
I Removing the Unit 1 Refer to the section �Removing the hard rubber frame� and
then remove the hard rubber frame. 2 Remove the Hex-head screw with integral washer (M4�8) on the back panel.
2 Engage the catch pins on the removal tool and remove the
two locks on the upper level. Push upward the frame and pull it forward as shown in the figure.
3 Insert the two removal tools deeply into the slots on each
side, as shown.
Accessory6 Lock
Catch facing up
Catch Accessory3 Removal tool
Accessory3 Removal tool
3 When the upper level is removed, remove the lower two
locations.
4 Push upward the removal
tool toward the top, and pull out the unit halfway whilst pressing towards the inside.
2CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
5 Pull the unit all the way out
with your hands, being careful not to drop it.
NOTE
The frame can be removed from the bottom side in the same manner.
