|
|
|
Usuarios conectados
Actualmente hay 6043 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
KDC-C20V
TEST MODE / ADJUSTMENT / CAUTION
How to enter
1. Connect the changer to the H/U. 2. While holding the magazine eject button of the changer, press the reset button of the H/U. 3. After about 3 seconds, release the magazine eject button. 4. Press the SRC button of the H/U to enter the CD-CH mode, and the H/U�s display section indicates �E-88�. (NOTE) In the E-88 mode, the initial position detection operation at the time or reset start is not performed. operated manually using the Track UP/DOWN and Disc +/ - keys. 1. Track UP key: Operates the Spindle/Loading motor in the direction for pulling the disc tray into the mechanism deck. 2. Track DOWN key: Operates the Spindle/Loading motor in the direction for returning the disc tray into the magazine. 3. Disc + key: Operates the Elevator motor in the direction for moving the mechanism deck upward. 4. Disc - key: Operates the Elevator motor in the direction for moving the mechanism deck downward.
Manual operation functions
The E-88 display appears when the H/U is set to the changer mode. In this condition the changer mechanism can be
ADJUSTMENT
L.P.S. initial position adjustment procedure
1. Connect the changer to the H/U. 2. While holding the magazine eject button of the changer, press the reset button of the H/U. 3. After about 3 seconds, release the magazine eject button. 4. Press the SRC button of the H/U to enter the CD-CH mode, and the H/U�s display section indicates �E-88�. 5. Move the mechanism deck to around the 1st stage by pressing the DISC- or DISC+ button. 6. Insert the adjustment tool (W05-0635-00) into the tool hole on the changer mechanism. 7. Then press the DISC+ button to move the mechanism deck until the mechanism�s slider hits the adjustment tool. 8. When the motor locks (stops), press the REPEAT key of the H/U. When the REPEAT key is pressed, the mechanism moves automatically to the 1st stage and the initial position adjustment completes. (The data is written in the EEPROM at this time.)
W05-0635-00
CAUTION
Note on IC8 (EEPROM)
Be sure to use the W05-0870-00 when replacing the EEPROM. IC8 stores the digital servo data of the pick-up servo. Therefore, if the EEPROM does not store servo data, ERROR76 (E-76) will indicate the H/U' s display section at the moment CD is played.
8
|
|
|
> |
|
