JVC KD-AR3000UC
Manual de Usuario

SOUND ADJUSTMENTS
ENGLISH

Adjusting the sound
You can set the speaker output balance, subwoofer output level, and input level of each source. � There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.

2

Make adjustments.
� To adjust fader and balance�Fad, Bal: You can make these two adjustments at the same time. � If you are using a two-speaker system, set the fader level to �00.� � Press 5 (up) or � (down) to adjust the fader. � Press ¢ or 4 to adjust the balance.

1

Select the item you want to adjust.
The next-step-operation buttons start flashing. Each time you press the button, the adjustable items change as follows:

iEQ

Fad/Bal

Sub Out

� To adjust subwoofer output�Sub Out: This takes effect only when a subwoofer is connected.

Canceled

Theme

Vol Adj

To increase the level To decrease the level

� For iEQ (sound mode) settings, see pages 25 � 27. � For THEME (display theme) settings, see page 28. Indication Fad To do: Adjust the front and rear speaker balance. Adjust the left and right speaker balance. Range R06 (Rear only) | F06 (Front only) L06 (Left only) | R06 (Right only)

Bal

You can also set an appropriate cutoff frequency level according to the subwoofer connected. � Press ¢ or 4 �Mid,� or �High.� Low: Mid: to select �Low,�

Sub Out

Adjust the 00 (min.) subwoofer output | level and cutoff 12 (max.) frequency level. Low/Mid/High Adjust and store the input level of each source. �12 (min.) | +12 (max.)

Frequencies higher than 50 Hz are cut off to the subwoofer. Frequencies higher than 80 Hz are cut off to the subwoofer.

Vol Adj

High: Frequencies higher than 115 Hz are cut off to the subwoofer.

24