No hay comentarios de productos.
Kappa 102a
INSTALLATION
The Kappa 102a is easy to install. For optimum performance, we recommend using high-quality, twistedpair shielded RCA audio cables and 14-gauge or larger speaker wire. Also, you�ll need a minimum of 12-gauge stranded copper wire (e.g., red and black jackets) for the power connections. Use 18-gauge (e.g., blue jacket) wire for remote turn-on. Depending on your total system plan, allow for adequate time and the possibility of overnight storage of your vehicle, since it may take more than one day to complete the installation.
MOUNTING THE AMPLIFIER...
The Kappa 102a can be mounted in virtually any location inside the vehicle. However, make sure to keep the amplifier away from heater vents or ducts. 1. At the chosen site, use the amplifier as a mounting template and mark locations of the four mounting holes. 2. Drill a small pilot hole at each marked location. 3. Mount the amplifier and securely tighten the mounting screws.
PARTS LIST...
Examine and verify that the package includes the following items: � (1) Kappa 102a Power Amplifier � (1) Spare ATC fast-blow fuse (40 A) � (1) Control cover with (2) machine screws � (1) Weco 5-pin audio connector � (1) Weco 2-pin power connector � (4) #8 mounting screws
WIRING THE AMPLIFIER...
Refer to Figure 7 (below) for details of the Kappa 102a�s front and rear panel connections. 1. For power, remote, and speaker wires, strip 1 �4" off one end of each jacket to reveal bare wire for insertion into the Weco connectors. 2. Using the Weco 2-pin power connector, connect a black wire from the nearest bare-metal chassis component to the (�) terminal. Then, connect a red wire from the vehicle�s +12-volt battery terminal to the (+) terminal.
KAPPA 102a WIRING CONNECTIONS
(front panel)
KAPPA 102a WIRING CONNECTIONS
(rear panel) Figure 7. Wiring connections for the Kappa 102a amplifier.
7
|