Dubbing (Multi-dubbing)
Do not connect the AC power cord until all other connections have been made. You can dub a video program from VCR 1 to VCR 2 and vice versa.
This shows an example of several possible connections. Also refer to the instruction books of the other components you are using for operation and connection details.
(green) To Component Video Output
(red)
VCR1 (Playback component)
: Signals from VCR 1 to VCR 2
To AUDIO Input To AUDIO Input To S-VIDEO Input
: Signals from VCR 2 to VCR 1
(white)
(red)
To Component Video Input
JX-S333 rear panel
(green) (blue) (red)
(green) (blue) (red)
To AUDIO Input
(white) (white) (red)
TV monitor
(red)
(red)
To S-VIDEO Input
(white) (red)
To S-VIDEO Output
To AUDIO Output
VCR2 (Recording device)
Connection tips � Before making any connections, turn off the power to all components. � It is not required to connect the components using both SVIDEO and component video connectors. To obtain the best possible playback picture on the TV monitor, connect the component using the component video connectors. However, to dub the tapes, it is required to connect the playback components through the S-VIDEO connectors. � If both the S-VIDEO and component video connectors are connected between the components, the incoming signals are emitted through the respective output connectors. (� P. 7 �Video input/output signals�)
(white)
(blue)
(white)
(red)
� The INPUT 1 and INPUT 2 connectors are used for connecting the playback/recording components. Incoming signals from the INPUT 1 and INPUT 2 connectors are emitted through the MONITOR OUT connectors and at the same time... � Signals from the INPUT 1 connectors are emitted through the OUTPUT 2 connectors. � Signals from the INPUT 2 connectors are emitted through the OUTPUT 1 connectors.
