ROLAND JV-1010
Guía de consulta rápida

®������®

64-Voice Synthesizer Module

JV-1010

TurboStart
For PC: 1. Connect a RSC-15AT serial cable from the serial port of the JV-1010 to the computer�s serial port (RS-232C). 2. Set the COMPUTER switch on the rear panel to PC-2. 3. Turn the power for all devices on. For Mac: 1. Connect a RSC-15APL serial cable from the serial port of the JV-1010 to the computer�s serial port. 2. Set the COMPUTER switch on the rear panel to Mac. 3. Turn the power for all devices on. Using MIDI: 1. Set the COMPUTER switch on the rear panel to MIDI. 2. Connect a MIDI cable from the JV-1010�s MIDI OUT to the MIDI IN of the MIDI interface. 3. Connect a MIDI cable from the JV-1010�s MIDI IN to the MIDI OUT of the MIDI interface. 4. Turn the power for all devices on.

Auditioning Patches (Phrase Preview)
The Phrase Preview function allows you to audition sounds at the touch of a button. A short sample of the selected patch is played in a style associated with that sound. Use the following procedure to try the Phrase Preview function: 1. Press the VALUE knob to select the Patch mode. 2. Turn the CATEGORY/BANK knob to select Session. 3. Turn the VALUE knob to select 023. 4. Hold down the VOLUME knob to hear the selected patch.

Using the JV-1010 as a GM Module
The JV-1010 features a GM (General MIDI) mode that provides a convenient way to play back or create General MIDI-compatible files. Use the following procedure to place the JV-1010 into GM mode: 1. Press the VALUE knob repeatedly to select GM.

Configuring the JV-1010 with SoundDiver
A copy of Emagic�s SoundDiver is included for patch editing on the JV-1010. This software allows you to quickly and easily edit the parameters of the JV-1010 from your Mac or PC. Before you can do this, it is necessary to configure the JV-1010 for use with your computer. First, you will need to connect the proper cable�for PC use RSC15AT, for Mac use RSC-15APL�to the serial port on your computer. Or, if you already have a MIDI interface, connect the MIDI ports on the JV-1010 to your interface. Make sure the power for the JV-1010, the computer, and any additional devices is turned off, and use the following procedures to configure the JV-1010 for use with SoundDiver.

TBS98

© 1999 Roland Corporation U.S., 5100 S. Eastern Ave., Los Angeles CA 90040

Faxback # 20094

Page 2