|
Usuarios conectados
Actualmente hay 6030 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Common
Questions
& Answers
Dishwasher
Won't Fill?
, � � � � � � , , , � � �
Be sure door is latched securely. Be sure the water is turned on. Check that the dial/pad is properly selected for a cycle. Allow time for select models to drain/pause before filling. Check your home's circuit breaker or fuse box. Check inlet hose for a kink. Check water valve inlet for sediment and clean if necessary. if connected to a food waste disposer, be sure the knock-out is removed from the disposer inlet. Be sure the drain hose is elevated at least 32" so water cmmot drain back into the rob. Check for food obstruction in the drain or disposer. Check drain hose for a kink. Check your home's circuit breaker or fuse box. Check that the cycle is completed.
Dishwasher Drain/Water Bottom?
Won't in Tub
Detergent Empty?
Cup Not
� Check that the cycle is completed. � Be sure dispenser is not blocked. � Use fresh detergent which has been stored in a cool, dry place. A water valve hiss during fill is normal. Water circulation sounds are normal. A ticking noise is a normal timer sound (select models). A thumping sound may be a wash arm bumping an item that is extending beyond the racks. Chopping or grinding sounds may be heard during drain as the internal food disposer chops hard items like fruit seeds, nuts etc. Humming during drain is normal. � A snap noise is the detergent cup lid hitting the door liner. This is normal. Proper installation affects the noise level. � Super Scrub Plus or Sanitize has been selected and the cycle is being extended to heat water. � Check to see that the incoming water temperature is 120-140 ° F (49-60 ° C). � Run dishes being held in the dishwasher through a Rinse Only cycle. � � � � �
Seems Noisy?
Cycle Takes Too Long (Heating Delay fight stays on)?
Has an Odor?
* � � �
Many dishwashers have a "new" smell when first installed. This will dissipate with use. A chemical odor is usually the chlorine bleach in dishwasher detergents. Try another brand. Dishwasher may not be draining properly. (See "Won't Drain" section.) For a strong odor try placing baking soda in the detergent cup. Select Light Wash and allow the water to circulate for about 10 minutes. Interrupt the cycle by unlatching the door and let it stand overnight. Restart the dishwasher by latching the door and allow it to complete the cycle. Another alternative is to use a commercial dishwasher cleaning product such as Jet-Dry Dishwasher Cleaner*.
Dishwasher Adds Water at END of Cycle? Sanitized Light Does Not Illuminate at the End of the Cycle? Display Time Suddenly Drops or Increases by Several Minutes
� This is normal. The Auto Clean sensor in the pump must stay submerged so a short fill of water is added after the cycle's last drain. , Sanitize was not selected. . Sanitization can only be achieved with the Auto Clean, Heavy, Light, or Normal cycles. � The incoming water temperature was too low, interfering with the dishwasher's ability to achieve adequate water heating in the allotted amount of time. * This is normal when the Auto Clean Cycle is selected and the dishwasher decides to skip or add a drain and refill.
|
|
|
> |
|