|
No hay comentarios de productos.
JAA33751-R.3646.A
�Mechanical Lock Inspection �When the mechanical lock inspection is made, write the inspection result data as the adjustment value. The below 1 and 2 screens are displayed alternately, so turn the VR switch to ON/OFF 5 times for the lens position 0 and 90 degrees respectively, according to the indicated instructions.
Screen 1.
Screen 2.
��When "OK" is shown on the execution screen, point the cursor to "Next" button and click it.
�When the message "Finished rewriting checksum value" is shown, click "OK" button. Turn the VR switch to OFF according to the message, and click "OK" button to exit the adjustment screen. Note: If "NG" is shown during the adjustment, click "Next" button to exit the inspection mode. Go back to the Lens Selection screen after rewriting the checksum value, and make the adjustment again. If "NG" appears even after making the adjustment a few times, the VR unit, the gyro PCB, and the main FPC, etc should be defective.
- Ａ57�AF-S VR300/2.8G -
|
