|
No hay comentarios de productos.
CHAPTER 3 STANDARDS AND ADJUSTMENTS
5. Fixing System
5.1 Points to Note When Mounting the Fixing Heater
1) Do not touch the surface of the heater. 2) For both heaters, be sure that the side with the longer harness is toward the front. 3) Mount the main heater [1] to the right side and the sub heater [2] to the left side (viewing from the front of the fixing assembly). 4) Be user that the protrusions of the heaters will not interfere, i.e., stagger them. 5) When mounting the faston to the fixing heater at the rear, do not bend the faston terminals (A, B) as if to direct it toward the outside. Be sure it is parallel to the holder.
5.2 Position of the Fixing Inlet Guide
� Points to Note When Making Adjustments in the Field 1) For the position of the inlet guide, see the instructions under 2.4.1, i.e., adjusting the position of the fixing inlet guide solenoid (SL1). 2) The inlet guide will move down when the solenoid (SL1) turns on. 3) The difference in the height of the inlet guide between front and rear must be within 0.5 mm. 4) The height of the inlet guide may be adjusted by loosening the fixing screw on the height adjusting support plate.
Removing the inlet guide base will require adjustment of the position of the inlet guide. To avoid the adjustment, try not to loosen the mounting screw on the inlet guide base. If you loosened it for some unavoidable reason, be sure to position it correctly with reference to the index on the fixing assembly base.
3-22 T
COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000
|
