The following error codes are associated with the line condition at time of reception: ##107, ##114, ##201 Be sure to change bit 4 before changing this bit; resort to this bit only if an error still occurs. When set to �1�, only high-speed (image) signals will be received after the transmission of the CFR signal.
[Bit 4] Use it to select the length of time during which low-speed signals are ignored after transmission of the CFR signal. Select �1500 msec� if reception of image signals is not good because of a poor line condition. [Bit 7] Use it to specify whether or not to send the CED signal at time of manual reception. Set it to �transmit� if the other party does not start transmission when manual reception is initiated.
