No hay comentarios de productos.
3-249-145-21 (1)
FM/AM Clock Radio
Operating Instructions
� Since a strong magnet is used for the speaker, keep away personal credit cards using magnetic coding or spring-wound watches from the unit to prevent possible damage from the magnet. � When the casing becomes soiled, clean it with a soft dry cloth moistened with mild detergent solution. Never use abrasive cleansers or chemical solvents, as they may deform the casing. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.
Choosing Power Sources
(See Fig. A) Installing the Batteries
Press the tab of the battery compartment lid inward and pull upward to open the lid. Install two Size AA (R6) batteries (not supplied) with the correct polarity and close the lid. �AM12:00� flashes in the display when you install batteries for the first time. To stop the display from flashing, set the clock. (See �Setting the Clock.�) Note When operating the unit on batteries, remove the AC power adaptor from the DC IN jack. The unit cannot be operated on batteries when the AC power adaptor is connected to the DC IN jack. Battery Life (Approx. hours) When using Sony alkaline size AA (LR6) Sony size AA (R6) FM 68 27 (JEITA*) AM 71 30
A
Bottom
B
Rear
Troubleshooting
Should any problem occur with the unit, make the following checks to determine whether or not servicing is required. If the problem persists, consult your nearest Sony dealer. The clock does not show the correct time. � Has an electrical power outage lasting more than 4 minutes occurred?
Size AA (R6) � 2
To DC IN 4.5 V jack
AC power adaptor To a wall outlet
ICF-C630
Sony Corporation © 2003 Printed in China
DREAM MACHINE is a trademark of Sony Corporation.
The radio, buzzer or melody alarm does not sound at the preset alarm time. � Has the desired radio, buzzer or melody alarm been activated? (i.e. Is the ALARM or ALARM indication lit?) The radio alarm is activated but no sound comes on at the preset alarm time. � Has a station been tuned in before setting the radio alarm? � The volume is set to the minimum level. Very weak or interrupted sound, or unsatisfactory reception. � Weak batteries. � When in a vehicle or building, move closer to a window. Display is dim, or no indication is displayed. � Weak batteries. � The unit is being used in extremely high or low temperatures or in a place with excessive moisture. Sound is not heard and �E� appears in the display. � Batteries are exhausted.
Insert the # side of the battery first.
For customers in the USA Please register this product on line at http://www.sony.com/productregistration. Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you.
* Measured by JEITA (Japan Electronics and Information Technology Industries Association) standards. The actual battery life may vary depending on the circumstance of the unit. When to replace the batteries When the batteries become weak, the sound becomes weak and distorted. �E� flashes on the display. When the batteries are completely exhausted, �E� appears on the display and the power is turned off. Note on replacing the batteries Do not take more than 3 minutes to replace the batteries, otherwise the clock and standby settings will be deleted from the memory. Should that happen, reset the functions again. After the batteries are replaced, press RADIO ON/ OFF to turn the indication off. Notes on Batteries � Do not charge dry batteries. � Do not carry dry batteries together with coins or other metallic objects. It can generate heat if the positive and negative terminals of the batteries accidentally come into contact with metallic objects. � Do not use different types of batteries at the same time. � When you replace the batteries, replace all with new ones.
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Features
� Dual alarm FM/AM clock radio. � You can set Radio and Melody alarms to defferent time. (You can select Melody sound from the following; 1. Buzzer, 2. �Morning� from �Peer Gynt,� by Grieg - suite No.1, Op.46, 3.�For Eliza� by Beethoven.) � Triple display�main display for the clock, and two sub-displays for the alarms. � Nap timer�Count down Timer (10,20,30,60,90,120 minutes) � Extendable Snooze time from 10 to 60 minutes. � LCD with brightness adjustment backlight. (High/ Medium/Low) � D.S.T. (Daylight Saving Time)�Summer time adjustment (one-hour skip function). � AC/DC operation�You can place the radio anywhere you like using it with the AC power adaptor or the batteries.
Specifications
Time display: 12-hour system Frequency range: FM: 87.5�108 MHz AM: 530�1 710 kHz Speaker: Approx. 5.7 cm (1/4 in), 4 � Power output: 120 mW (at 10% harmonic distortion) Power requirements: 3 V DC, two Size AA (R6) batteries External power source: DC IN 4.5 V Dimensions: Approx. 94 � 104 � 82 mm (w/h/d) (3 3/4 � 4 1/8 � 3 1/4 in) incl. projecting parts and controls Approx. 94 � 103 � 82 mm (w/h/d) (3 3/4 � 4 1/8 � 3 1/4 in) not incl. projecting parts and controls Mass: Approx. 313 g (11 oz) incl. batteries Accessories supplied: AC power adaptor (1) Design and specifications are subject to change without notice.
INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: � Reorient or relocate the receiving antenna. � Increase the separation between the equipment and receiver. � Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. � Consult the dealer or an experienced radio/ TV technician for help.
Using House Current (See Fig. B)
Connect the Sony AC power adaptor to the DC IN 4.5 V jack firmly, and plug it into a wall outlet. The power source will automatically switch to the external power source even if batteries are installed. Notes on the AC power adaptor � When operating the unit with an external power source, do not remove the batteries. These batteries serve to backup the clock and standby settings. Since batteries discharge in this case as well, we recommend changing them about once a year. � Before connecting and disconnecting the external power source plug, be sure to turn off the radio. Otherwise, �E� may be displayed. When this occurs, turn on the radio so that �E� disappears. � When operating the unit with the internal batteries, remove the AC power adaptor from the wall outlet and the DC IN 4.5 V jack. Make sure that the plug of the external power source is disconnected before operating the unit. � Use the recommended Sony AC power adaptor only. The polarity of the plugs of other manufacturers may be different. Failure to use the recommended AC power adaptor may cause the unit to malfunction.
Precautions
� Operate the unit only on 4.5 V DC. For battery operation, use two size AA (R6) batteries. For AC operation, use only the recommended AC power adaptor. � The unit is not disconnected from the AC power source (mains) as long as it is connected to a wall outlet, even if the unit itself has been turned off. � The nameplate indicating operating voltage, etc. is located on the bottom exterior. � Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust or mechanical shock. Never leave in a car parked under the sun. � Should any solid object or liquid fall into the unit, disconnect the AC power adaptor and remove the batteries, and have the unit checked by qualified personnel before operating it any further. Make sure that no liquid or foreign material enters the DC IN 4.5 V jack of the unit. This may lead to the malfunction of the unit. � In vehicles or buildings, radio reception may be difficult or subject to interference. Try listening near a window.
Before You Begin
Thank you for choosing the Sony Dream Machine! It will give you many hours of reliable service and listening pleasure. Before operating the radio, please read these instructions thoroughly and retain them for future reference.
Polarity of the plug
