SONY ICD-BM1PRO
Manual de Servicio

ICD-BM1/BM1PRO

Replacing the Batteries
The battery indicator on the display window shows the battery condition.

Step 2: Setting the Clock
You need to set the clock to use the alarm function or record the date and time. Clock setting display appears when you insert battery for the first time, or when you insert battery after the unit has been without battery for a certain period of time. In this case, proceed from step 4.
Jog lever Press up (>). MENU POWER ENTER CANCEL Press down (.).

Notes
� Do not use manganese batteries for this unit. � When you replace the batteries, insert the new ones within 3 minutes after you remove the exhausted ones. Otherwise, the display may show the clock setting or incorrect date and time when you re-insert the batteries. In this case, set the date and time again. The recorded messages and alarm setting, however, will remain. � Do not charge dry batteries. � When you are not going to use the unit for a long time, remove the batteries to prevent damage from battery leakage and corrosion.

Battery remain indication
: Replace both of the two batteries with new ones. m : The �LOW BATTERY� is displayed and the unit will stop operation.

Battery life (Using Sony alkaline batteries LR03 (SG))
(Recording mode:) In continuous recording: In continuous playback*: ST Approx. 11 hours Approx. 6.5 hours SP Approx. 14 hours Approx. 7.5 hours LP Approx. 16 hours Approx. 8.5 hours

1

Slide POWER to ON.
The IC recorder is turned on.

* When playing back through the internal speaker with the medium volume level * The battery life may shorten depending on the operation of the unit.

2

Press MENU.
The menu mode will be displayed in the display window.

3

Press the jog lever up or down (>/ .) to select �DATE&TIME�.

7GB

8GB

4

Press ENTER.
The date and time setting window is displayed. The year digits will flash.

Step 3: Inserting a �Memory Stick� into the IC Recorder
Notes
� Make sure to insert or remove the �Memory Stick� while the unit is turned off. � Never remove the �Memory Stick� while the unit is accessingthe �Memory Stick�. (The OPR indicator flashes in orange.)

5

Set the date and time.
1 Pressthe jog lever up or down (>/ .) to select the digits of the year. 2 PressENTER. The month digit will flash. 3 Set the month, day, and the time in sequence,then press ENTER. The menu mode will be displayed again.

Getting Started

1

Slide and open the �Memory Stick� slot cover.

6

Press MENU.
The window will return to the normal display.

2
To cancel the operation
PressCANCEL to return to the previous step of the operations.

Insert a �Memory Stick� into the �Memory Stick� slot with the terminal side facing inside the recorder. Insert it firmly until it clicks into place.

To display the current time
Press ENTER while the unit is in the stop mode (page 27). The current time will be displayed for three seconds. Note
When no �Memory Stick� is inserted or the power is turned off, the current time will not be displayed.

Note
Do not insert a �Memory Stick� in a different direction. It may cause malfunction of the unit.

3

Close the �Memory Stick� slot cover.

9GB

10GB

4