Installing Your Ice Maker
How to Prepare the Freezer Compartment
1 2
Remove freezer accessories, including all baskets and shelves. water connection cover from top left corner of freezer section. Remove electrical and
� Remove screw from cover and discard screw and cover.
8
Insert fill tube into rear water outlet. Press thumb into center of grommet until an audible snap is heard.
� Pull on grommet to be sure that the fit is tight. If tube comes loose, repeat above instructions.
� See Owner�s Manual on instructions on removal and replacement of freezer items.
How to Mount the Water Valve Assembly
3
Remove wall plugs and water tube inlet cover on rear freezer wall with flat blade screwdriver blade covered with masking tape. Locate water inlet cover on rear of unit. Remove with flat blade screwdriver blade wrapped in masking tape, and discard. Detatch bottom left corner machine compartment cover with ¼� hex head driver.
1
Remove wire harness from machine compartment cover with needle-nose pliers. Attach water valve to machine
4
2
compartment cover with ¼� hex head screw from ice maker kit.
5 6 7
3 4 5
5
Locate plastic compression nut from ice maker kit, and slide over exposed end of water line. Locate anti-kink spring from ice
Cover end of fill tube (D) with masking tape or small plastic bag to avoid insulation from entering tube during insertion. Remove plastic water tube from water valve and feed plastic water tube through cabinet hole beneath rear water inlet until it appears in the exposed machine compartment.
� Retain plastic nut from water tube removal for later use.
maker kit, and insert into exposed end of water line.
Insert exposed end of water line into water outlet of valve and tighten compression nut.
