JVC HX-Z9UB
Manual de Usuario

Using the Timers
There are three timers available�DAILY (Daily Timer), REC (Recording Timer), and SLEEP (Sleep Timer). You can set the timers whether the unit is on or off; however, if Ecology Mode is activated, you cannot set the timers while the unit is off. Before using the timers, set the clock built in the unit. (See page 10.)

Continued

On the unit ONLY:

1

Press CLOCK/TIMER repeatedly until �DAILY� appears on the display.
The (Timer) indicator lights up and the DAILY (Daily Timer) indicator also starts flashing on the display.
D A I LY

CLOCK / TIMER

Using Daily Timer
With Daily Timer, you can be wake up with your favorite music or radio program. � Each time you press the button, the timer setting modes change as follows:
DAILY Canceled TIMER
(Daily Timer setting)

How Daily Timer actually works
The unit automatically turns on, sets the volume level to the preset level, and starts playing the specified source when the on-time comes. (�DAILY� and the DAILY indicator flash just before the on-time, and the DAILY indicator continues flashing while the timer is operating.) Then, when the offtime comes (�DAILY OFF� flashes just before the off-time), the unit automatically turns off (on standby). The Daily Timer works everyday automatically. If you do not want to use the Daily Timer, turn it off. (See �To turn on or off Daily Timer after its setting is done� on page 23.) The timer setting remains in memory until you change it. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. � To correct a misentry while setting the timer, press CANCEL/DEMO.

REC TIMER

(Recording Timer setting) (The hour digits start flashing.)

Clock setting

2

Press CLOCK/TIMER again.
�TIMER� appears for about 2 seconds, then the unit enters on-time setting mode.
D A I LY

CLOCK / TIMER

3

Set the on-time you want the unit to turn on at.
1) Turn 4 / ¢ to set the hour, then press SET/DISPLAY. 2) Turn 4 / ¢ to set the minute, then press SET/DISPLAY. �SET� appears for about 1 second, then the unit enters off-time setting mode.

PRESET

Before you start... � When using a disc as the source to play� � Make sure there is a disc on the selected disc tray. � When using a tape as the source to play� � Make sure that a tape is in the cassette deck. � Make sure that the tape direction is correct. � When using the external component as the source to play� � Set the timer equipped on the external component at the same time.

SET / DISPLAY

D A I LY

22

English