JVC HX-Z30UU
Manual de Usuario

English

Using the Timers
There are three timers available�DAILY (Daily Timer), REC (Recording Timer), and SLEEP (Sleep Timer). � Before using the timers, set the clock built in the unit. (See page 9.)

On the unit ONLY:

1

Press CLOCK/TIMER repeatedly until �DAILY� appears on the display.

CLOCK /TIMER

Using Daily Timer
With Daily Timer, you can wake up to your favorite music or radio program. � You can set the timers whether the unit is on or off.

The (Timer) indicator lights up and the DAILY (Daily Timer) indicator also starts flashing on the display.

How Daily Timer actually works
The unit automatically turns on, sets the volume level to the preset level, and starts playing the specified source when the on-time comes. (�DAILY� and the DAILY indicator on the display flash just before the on-time. The DAILY indicator continues flashing while the timer is operating.) Then, when the off-time comes (�DAILY OFF� appears on the display just before the off-time), the unit automatically turns off (standby). The Daily Timer works everyday automatically. If you do not want to use the Daily Timer, turn it off. (See �To turn on or off Daily Timer after it has been set� on page 24.) The timer setting remains in memory until you change it. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. � To correct a misentry while setting the timer, press CANCEL/DEMO.

� Each time you press the button, the timer setting modes change as follows:
DAILY Canceled
(Daily Timer setting)

TIMER Clock setting

REC TIMER

(Recording Timer setting)

(The hour digits start flashing.)

2

Press

CLOCK/TIMER again.
CLOCK /TIMER

�TIMER� appears for about 2 seconds, then the unit enters on-time setting mode.

3

Set the on-time you want the unit to turn on at.
1) Turn ¢ / 4 to set the hour, then press SET/DISPLAY. 2) Turn ¢ / 4 to set the minute, then press SET/DISPLAY. �SET� appears for about 1 second, then the unit enters offtime setting mode.
PRESET

NIN

Before you start... � When using a disc as the source to play: � Make sure there is a disc on the selected disc tray. � When using a tape as the source to play: � Make sure that a tape is in the cassette deck. � Make sure that the tape direction is correct. � When using an external component as the source to play: � Set the timer equipped on the external component to the same time.

SET /DISPLAY

T U G

4

Set the off-time you want the unit to turn off (standby) at.
1) Turn ¢ / 4 to set the hour, then press SET/DISPLAY. 2) Turn ¢ / 4 to set the minute, then press SET/DISPLAY. �SET� appears for about 1 second, then the unit enters source selecting mode.

23