JVC HXZ3
Manual de Servicio

HX-Z3 Removing assembly the power transformer (See Fig.28, 29)
Power transformer assembly

Prior to performing the following procedure, remove the metal cover, the CD changer mechanism assembly, the rear panel, the main board and the bridge board / regulator board. 1. Remove the screw N attaching the primary board. 2. Disconnect the wire from connector CN231 and CN232 on the primary board.

N
3. Remove the four screws O transformer assembly. attaching the power Fig.28

Primary board

4. Cut the tie band and detach power cord from primary board. REFERENCE: When disconnecting the power cord from connector CN250 on the primary board, remove the fixing band.
Primary board CN231, CN232 Power transformer assembly CN250

O

Fixing band

<Front panel assembly>
Prior to performing the following procedure, remove the metal cover, the CD changer mechanism assembly and the front panel assembly.

O
Fig.29

Cord stopper

Removing assembly

the

cassette

mechanism (See Fig.30)

Head amplifier & mechanism control board CN33 Band

1. Disconnect the card wire from connector CN33 on the head amplifier & mechanism control board. 2. Remove the two screws P, and the two screws Q attaching the cassette mechanism assembly. 3. Cut the band.

P

Q

Removing the headphone board (See Fig.30)
1. Remove the screw Q attaching the wire extending from the headphone board. 2. Remove the screw R and pull out the headphone board backward.
Cassette mechanism assembly

QR

Headphone board

Fig.30

1-13