Removing the cams R1/R2 assembly and cam gear q(See Fig.22)
Slit washer 1. Remove the slit washer fixing the cams R1 and R2 assembly. 2. By removing the two pawls "w" fixing the cam R1, separate R2 from R1. 3. Remove the slit washer fixing the cam gear "q". 4. Pull out the cam gear "q" from the C.G. base assembly. Cam gear q
Slit washer Cam R2
J
Pawl
w
Pawl
w
Removing the C.G. base assembly (See Fig.22 and 23)
Remove the three screws J retaining the C.G. base assembly. [Caution] To reassemble the cylinder gear, etc.with the cam unit (cam gear and cans R1/R2 assembly), gear unit and drive unit, align the position of the pawl "x" on the drive unit to that of the notch on the cam gear "q". Then, make sure that the gear unit is engaged by turning the cam gear "q" (See Fig. 24).