JVC HX-Z10SU
Manual de Usuario

Creating Your Own Sound Mode�User Mode
You can change the SEA pattern to suit your preference. The SEA pattern can be adjusted using 3 frequency ranges�BASS, MID (middle), and TRE (treble). These changed settings can be stored as the USER 1, USER 2, and USER 3 modes. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

To use your own sound mode
Select USER 1, USER 2, or USER 3 mode when using the sound modes. See �Selecting the Sound Modes� on page 11.
When you unplug the AC power cord or if a power failure occurs The setting will be erased in a few days. If this happens, set the user modes again.

On the unit ONLY:

1

Select one of the preset sound modes.
� If you want to add surround elements into your SEA pattern, select one of the surround modes (DANCE, HALL, or STADIUM) before starting the procedure below. (See �Selecting the Sound Modes� on page 11.)

Turning On or Off the Key-touch Tone
If you do not want the key-touch tone to beep each time you press a button or turn a control, you can deactivate it. The BEEP ON indicator goes off from the display.
T U G NIN

2

Press SET/DISPLAY while the selected sound mode is still shown on the display.

SET /DISPLAY

On the unit:

Press and hold BEEP for more than 2 seconds.
On the remote control:

T U NIN G

/BEEP

Press BEEP ON/OFF.
� Each time you press the button, the keytouch tone turns on and off alternately.
Current level appears.

BEEP ON/OFF FADE MUTING

VOLUME

3

Adjust the SEA pattern.

PRESET

1) Turn ¢ / 4 to select the frequency range (BASS, MID or TRE). 2) Press ¡ or 1 to adjust the level (�3 to +3) of the selected frequency range. 3) Repeat steps 1) and 2) to adjust the level of the other frequency ranges.
T U NIN G
/BEEP

4

Press SET/DISPLAY again.

SET /DISPLAY

5

Turn ¢ / 4 to select one of the user modes (USER 1, USER 2, or USER 3) in which you want to store your SEA pattern. Press SET/DISPLAY again.

PRESET

6

The SEA pattern you have created is stored into the user mode selected in step 5.

12