|
No hay comentarios de productos.
3.1.5 Removing the rear panel (See Figs.10 to 12) � Prior to performing the following procedures, remove the metal cover. (1) From the top side of the main body, remove the tie band bundling the wires. (See Fig.10.) Reference: After reassembling, bundle the wires with the new tie band as before. (See Fig.10.) Disconnect the wire from the connector CN202 on the bridge board. (See Fig.10.) From the back side of the main body, remove the two screws G and screw H attaching the rear cover. (See Fig.11.) Release the sections c and remove the rear cover. (See Fig.11.) Remove the sixteen screws J attaching the rear panel. (See Fig.12.) From the both sides of the main body, release the joints d attaching the rear panel to the chassis base and remove the rear panel with the fan. (See Fig.12.)
Tie band Bridge board
CN202 Wires
(2) (3)
(4) (5) (6)
3.1.6 Removing the fan (See Figs.10 to 12) � Prior to performing the following procedures, remove the metal cover. (1) From the top side of the main body, remove the tie band bundling the wires. (See Fig.10.) Reference: After reassembling, bundle the wires with the new tie band as before. (See Fig.10.) Disconnect the wire from the connector CN202 on the bridge board. (See Fig.10.) From the back side of the main body, remove the two screws G and screw H attaching the rear cover. (See Fig.11.) Remove the two screws K attaching the fan. (See Fig.12.) Take out the fan from the main body.
Fig.10
G
(2) (3)
H
c c
(4) (5)
c
Fig.11
Rear cover
Rear panel
J
J
Fan
K
K
J
d
J J
Fig.12
d
1-10 (No.MB188)
|
