AIWA HSPX597AEAK
Manual de Servicio

PRACTICAL SERVICE FIGURE
<TAPE PLAYER SECTION>
1. Tape Speed Adjustment Settings : � Test tape : TTA�100 (Tape center) � Test point : PHONES (J101) � DSL : OFF � Adjustment location : SFR301 � DOLBY SW : OFF<597 only> � TAPE SELECTOR : NORM(auto) � VOLUME : MAX Method : Play back (FWD) the test tape and adjust SFR301 so that the frequency becomes 3015Hz±10Hz. Then confirm WOW is less than 0.50%. 2. Dolby level check<597 only> � Test tape : TTA�200 Test tape : � Check point : TP1(RCH), TP2(LCH) � DOLBY SW : OFF � DSL : OFF � TAPE SELECTOR : NORM � VOLUME : MINI � Adjustment points : Soldering patterns 1 - 4 Precedure : Short the patterns via solder as showen in the table so ghe Dollby NR level is 32mV ± 1.0dB. Adjust so the specifications are satisfied in both theforward ans reverse directions. Connect 10uF/16V coupling capacetors between test points and test wquipment (connect the positive terminals to the test points). SODER POINT only 1 LCH only 2 1&2 only 3 only 4 3&4 INCRESE LEVEL 0.8 dB 1.5 dB 2.3 dB 0.8 dB 1.5 dB 2.3 dB Settings :

<TAPE SECTION>
Tape speed : Wow : Take-up torque : F.F torque : REW torque : S/N ratio : Distortion : Noise level :

Frequency response :

3015Hz ± 50Hz Less than 0.52% (RMS) 20 ~ 30g-cm (FWD, RVS) 70 ~ 150g-cm 70 ~ 150g-cm More than 42dB (PB, DC) Less than 3.0% (PB, DC) Less than 3.0mV (Vol MAX, PB, DC) Less than 0.4mV (Vol MIN, PB, DC) 63Hz + 3 / � 5dB ~ 8kHz + 4 / � 4dB (NORMAL) 63Hz + 3 / � 5dB ~10kHz + 4 / � 4dB (CrO2) TTA� 100 TTA� 200 TTA� 210 TTA�310(CrO2) TTA�320(NORMAL)

RCH

19