Instant Timer Recording (ITR)
The Instant Timer Recording feature provides a simple and convenient way to make a timed recording. Preparation: � Turn ON the TV and set it to the video input mode. � Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then press VCR to select the VCR mode. (The VCR indicator will light.) Example: Instant Timer Recording for 30 minutes.
TV VCR DVD POWER
1 Load a cassette tape with the erase
prevention tab intact. The VCR will automatically turn on.
DVD MENU DISPLAY
MARKER A.TRK SUB TITLE
RETURN C.RESET ANGLE
OPEN/ CLOSE
2 Press SP/EP to select the desired tape
speed SP or EP. The tape counter and SP or EP will appear on the screen for about 4 seconds.
00 : 00 : 00 SP
ZERO RETURN
SEARCH MODE
SP/EP
PLAY MODE
ZOOM
TITLE
REPEAT A-B
TV
POWER INPUT
3 Set the TV/CATV option to the appropriate position (See page
19). TV - VHF/UHF channels CATV - CABLE TV channels
TV VOL
0
REW
TIMER
TV/VCR
PLAY
FF
4 Press Number keys or VCR CH +/� to select the channel to be recorded.
CH 110
EC R
STOP
PAUS
E
SKIP /INDEX
TV/VCR CH +
SKIP /INDEX
SET
SET UP MENU
ENTER/ SELECT
SET
CANCEL
5 Press REC on the VCR or while holding REC, press PLAY on
the Remote to begin recording. Press REC on the VCR again to stop recording after 30 minutes. Each additional press of REC will increase recording time as shown in the chart below, up to a maximum of 5 hours. The ITR and recording time will appear on the screen for about 4 seconds. And, REC will keep blinking in the display.
T V /V CR C H �
OSD
A.MONITOR
SLOW
SKIPCH R SEA
VCR/DVD/TV
Press once twice 3 times 4 times 5 times
Recording time Press Recording time NORMAL REC 6 times 3:00 0:30 1:00 1:30 2:00 7 times 4:00 8 times 5:00 9 times NORMAL REC
ITR 0 : 30 CH 125
INDEX
NOTE: If you wish to watch the DVD playback during the ITR, press DVD to change to DVD mode and perform the DVD playback (see P.37).
To cancel ITR
Press STOP or turn off the power. " " will appear on screen for about 4 seconds.