JVC HR-S9400U
Manual de Usuario

48 EN
MENU

TIMER RECORDING (cont.)
You can directly program the VCR�s timer to record up to 8 shows, as far as a year in advance. Remember, the clock must be set before you can program the timer ( pg. 8 or 9). You can also use the optional Illumi-Guide feature, where the relevant buttons on the remote control light to tell you which button to press next. The Illumi-Guide feature is activated by the ILLUMI GUIDE button on the remote control. The Illumi-Guide feature is only active when the remote control's TV/CABLE/VCR switch is set to "VCR". (Illumi-Guide is an optional help feature which makes programming easier. It is not necessary to use Illumi-Guide to program the VCR.)

On-Screen Timer Programming
OK
8

LOAD A CASSETTE

1
CH

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load. � The VCR comes on, and the counter is reset, automatically.

ACCESS ON-SCREEN MENU

2
1 2 5 8 0 3 6 9

To use the Illumi-Guide feature press ILLUMI GUIDE. The MENU, REW, PLAY and FF buttons will light. Press MENU as many times as necessary to bring up the Main Menu screen. � If you are using the Illumi-Guide feature, MENU lights up and OK blinks.

NUMBER

4 7

ACCESS PROGRAM SET SCREEN
CH

Make sure the arrow is to the left of "PROGRAM SET",

3 4

then press OK. � If you are using the Illumi-Guide feature, OK blinks when the following buttons are lit: NUMBER keys (0 � 9), TIME SCAN, CANCEL and MENU.

SELECT PROGRAM NUMBER
OK MENU TIME SCAN ILLUMI GUIDE

Press the appropriate NUMBER keys or CH5� or TIME SCAN 5� to select a vacant program number, then press OK. The first time

PROGRAM 1 DATE START STOP CHANNEL --/-- - : - - AM - - : - - AM - - SP

you set the timer programPRESS NUMBER KEY(0-9) ming function, all the OR ( 5,�), THEN (OK) program numbers will be PRESS (MENU) TO END blank; in this case just press OK when the Program Set screen appears. � If you are using the Illumi-Guide feature, OK blinks when the following buttons are lit: NUMBER keys (0 � 9), TIME SCAN, CANCEL and MENU.

When Using The Illumi-Guide Feature
� Buttons light or blink on the remote control for approximately 10 seconds. If the button or buttons extinguish during timer programming, press ILLUMI GUIDE and the button or buttons previously lit or blinking come back on. If the button or buttons do not re-light or start blinking again, press MENU as many times as necessary to return to the normal screen and extinguish all illuminated buttons, and re-perform the timer programming procedure from the beginning. � If for some reason the remote control's signal is not received by the VCR, press MENU as many times as necessary to return to the normal screen and extinguish all illuminated buttons, and re-perform the timer programming procedure from the beginning.