JVC HR-J6005UM
Manual de Usuario

EN

21

Recording
Perform steps 1 � 3 on page 13 ("Simple Recording") before continuing.

1
PLAY
0
4

Press and hold REC and press PLAY on the remote control, or press REC on the VCR's front panel. � The VCR takes about 7 seconds to assess the quality of the tape in use, then recording begins with the picture level optimized.

START RECORDING
DURING B.E.S.T.

PLAY

START

END

+ + + B.E.S.T. PICTURE SYSTEM

REC

NOTES:
� B.E.S.T. occurs immediately prior to both the first SP and the first EP recording after inserting the cassette. It does not take place during �

B.E.S.T. COMPLETE

��

��

REC

PAUSE

PAUSE

START

END

3

� � �

Playback
The VCR assesses the quality of the tape once you start playback. Perform steps 1 and 2 on page 12 ("Simple Playback") before continuing.

recording. + + + In the case of timer B.E.S.T. PICTURE SYSTEM recording, B.E.S.T. takes place for both SP and EP before the first timer recording after inserting the cassette (regardless of the tape speed selected for that recording). Once the cassette is ejected, the B.E.S.T. data is canceled. The next time the cassette is used for recording, B.E.S.T. is re-performed. While B.E.S.T. is operative, the PAUSE button will not function. To display the B.E.S.T. Picture System, "SUPERIMPOSE" must be set to "ON" or the B.E.S.T. Picture System screen will not appear ( pg. 18).

ATTENTION
As B.E.S.T. takes place before recording actually starts, there is a delay of about 7 seconds after REC and PLAY on the remote, or REC on the VCR's front panel, are pressed. To make sure you record the desired scene or program completely, first perform the following steps: 1) Press and hold PAUSE, and press REC to engage the RECORD PAUSE mode. � The VCR then automatically checks the condition of the tape and, after about 7 seconds, re-enters RECORD PAUSE. 2) Press PLAY to start recording. If you want to bypass B.E.S.T. and start recording right away, set "B.E.S.T." to "OFF" in step 4 of the Preparation procedure ( pg. 20).

START PLAYBACK

1

Press PLAY. � The VCR adjusts the playback picture quality based on the quality of the tape in use.

B.E.S.T. PICTURE SYSTEM

NOTES:
� When using rental tapes, or tapes recorded on other VCRs, set �B.E.S.T.� in step 4 of the Preparation procedure to either �ON� or �OFF� as desired to give the best picture ( pg. 20). � The B.E.S.T. Picture System screen only appears at the beginning of automatic tracking. Even though the screen doesn't appear after that, the B.E.S.T. function is operative. � To display the B.E.S.T. Picture System screen, �SUPERIMPOSE� must be set to "ON" or the B.E.S.T. Picture System screen will not appear ( pg. 18).