� You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen. To record the extra programme, you must first cancel any unnecessary programmes ( pg. 21, "Check And Cancel Programmes"). � In case of a power failure after programming, the recorder�s memory backup keeps your selections (if the lithium battery is not exhausted).
NUMBER
7/
ATTENTION
Regarding Guide Program Number Set
"ERROR=GUIDE PROG" appears after performing step 3 on the previous page if the Guide Program number for the G-CODE number you entered has not been set. � If the recorder is in the stop or rewind or fast-forward mode, the following screen will appear with "� �" under "TV PROG" blinking. � Press the NUMBER keys or PUSH JOG %� to input the channel position number you recorder receives that station on, then press OK.
PUSH JOG
G-CODE SET-UP GUIDE PROG 2 TV PROG ��
2
1 ¶
1
3 7
4
¡ 8
¢
MENU
3
OK
(Ex.) To timer-record a SBS programme with G-CODE * If your recorder receives SBS on the channel position 2, press OK after entering "2".
[0-9] OR [5/�] : SELECT = [MENU] : EXIT
� Press MENU, then try again from step 1. � If the recorder is in a mode other than the above mentioned modes, press MENU first and input the correct Guide Program number for that G-CODE number ( pg. 14, "G-CODE Setup"), then try again from step 1.
