JVC HRDVS2U
Manual de Usuario

EN

41

INPUT RECEIVING CHANNEL NUMBER

5
1 4
T

The Guide Channel Number, which is assigned to the TV or cable station for the PlusCode number that you entered in step 4, will appear automatically

GUIDE CHANNEL SET

GUIDE CH: 12 VCR CH : � ��

2 5 8 0

W

3

6 9

2

NU

MB

ER

"9"

NUMBER "8" 7
CANCEL STOP+/�

4

TIMER

PRESS NUMBER KEY (0�9) on the Guide Channel Set OR (5,�), THEN (OK) screen. Input the number PRESS (PROG.) TO END of the channel on which the broadcast for the PlusCode number is received on the VCR or cable box using the NUMBER keys, CH +/� or %�, then press OK.

E P / P S

� The Guide Channel Set screen appears only when you input the PlusCode number of a station for which the
1
DV S-VHS

PROG.

Guide Channel number has not previously been set. � If you receive your channels with a cable box and if you have properly set your Controller, "CABLE CH" appears in place of "VCR CH". If not, refer to pages 15 � 17.

CHECK PROGRAM DATA

6
3

OK

The PlusCode number you entered and the matching Timer-Recording information is displayed on the Program screen. Check to make sure it�s accurate.

IMPORTANT
If you have moved to a different area or if a broadcasting station's channel number has been changed, the wrong VCR or CABLE CH number will be displayed on the VCR Plus+ program screen in step 6. When this happens, set the correct the Guide Channel number for that station. ( pg. 42, "Changing VCR Plus+® Setting")

� To change the stop time, press STOP +/�. � To timer-record daily or weekly serials, press DAILY (NUMBER key �8�) or WEEKLY (NUMBER key �9�). �DAILY� or �WEEKLY� appears on the Program screen. Pressing the button again makes each corresponding display disappear. � If you made a mistake, press CANCEL to access the VCR Plus+ screen again and input the correct PlusCode number. � If the PlusCode number you inputted is incorrect, "ERROR" may appear on the screen to advise you of the error. This happens when the PlusCode number is for a program which has already passed. "ERROR" is displayed for about 5 seconds and the VCR Plus+ screen reappears.

VHS PROGRAM 1 (VCR PLUS+ 12345678) START STOP 8:00PM = 10:00PM DATE CH 12/24/00 12 SP THU PRESS (8=DAILY, 9=WEEKLY STOP+/� = STOP TIME, SP/EP) PRESS (OK) TO END

SET TAPE SPEED

7 8 9

Press SP/EP (SP/LP for the DV deck).

NOTES:
� To disengage the timer before recording starts, press TIMER again. Pressing once more re-engages it. � In case of a power failure after programming, the VCR�s memory backup keeps your selections for approximately 60 minutes. � When timer-recording cable channels received through a Cable Box, be sure to keep the Cable Box set to ON. � It is not possible to timer-record the same programme on both the VHS deck and the DV deck simultaneously. � If the times that are programmed for recording on the DV deck and on the VHS deck overlap, the earlier start time takes precedence. If the start times are the same, the VHS deck takes precedence.

RETURN TO NORMAL SCREEN
Press PROG. or OK. "PROGRAM COMPLETED" appears on the screen for about 5 seconds, then normal screen appears. If "PROGRAM NOT COMPLETED PROGRAM OVERLAP" appears on the TV screen, see page 47.

ENGAGE TIMER MODE

Press TIMER. The VCR turns off automatically and "�" is displayed on the display panel.