PHILIPS HR8532
Manual de Servicio

Vacuum cleaner HR 8514 HR 8532 HR 8536 HR 8539

Philips Domestic Appliances and Personal Care

PRODUCT INFORMATION � � � � � � Maximum air displacement Maximum vacuum water column Power consumption (IEC) Dust storage capacity Cord length (depends on version) Filter system : : : : : : : : : : 32 I/sec 240 cm 1200 W 3l 6 or 8.5 metres Paper dustbag Motor inlet filter Exhaust air filter 44.5 x 29.5 x 25 cm 5.5 kg � Items 37,38 and 39 can be used if the version is provided with an electrically switched park assist. � Item 71 up to and including item 80. The assembly of accessories depends on the national version. To connect the nozzle, the telescopic tube and the handle: insert the narrowed section into the wider section while turning it a little (fig. 1). To disconnect: pull while rotating. To adjust the telescopic tube (item 74) to the required length, pull the locking knob in the direction of the arrow (fig. 2) while sliding the top section of the telescopic tube into or outof the lower section.

� Dimensions cleaner � Weight cleaner OPTIONAL � � � � � Exhaust air filter Sydney cotton dustbag Sydney paper dustbag Sydney closable pap.dustbag Turbo brush

HR 6932 = 4822 015 70056 HR 6997 = 4822 480 10115 HR 6998 = 4822 480 10114 HR 6999 = 4822 480 10113 HR 6988 = 4822 479 20196

SERVICE INFORMATION � To open the appliance, first remove the control panel (item 11) with a big screw driver to disconnect the 2 snap locks (see drawing). fig. 1 fig. 2

� Component configuration on exploded view may differ in case of specific versions. However, the actual components are distinguished bij means of code numbers. � If a repair has been made, make sure that all functions of the appliance are working correctly. � The spare parts have been standardized as much as possible. � Item 6, cotton dustbag, is used in those countries where paper dustbags are not available. � Item 21 is provided with a long cord-winder spring; both long and short cords can be used in combination with this spring.
Published by Philips Domestic Appliances and Personal Care

� To (dis)assemble the appliance use TORX screw driver no T15 = 4822 395 10329, which is one of a set consisting of T20, T15, TI0, T9, T8, T7 and T6 = 4822 395 50145. � Depending on the original length of the cord, the spare cord must be shortened. � Adjusting the PCB on the motor to 220V, 60Hz. 1. Make sure that the potentiometer (item 36) is set at min. position. 2. Adjust the potentiometer on the PCB item 45, on the motor to 220V/60Hz to allow the motor to run smoothly. Please note: the standard setting of the spare PCB is 230V/50Hz. There are open-circuit voltages on all wires. � MSH coding: 8838 514 00000 8838 532 00000 8838 536 00000 8838 539 00000 ( sahara yellow ) ( racing green ) ( blue purple ) ( california white )

Printed in the Netherlands

© Copyright reserved

Subject to modification

4822 729 21766 97/04
PCS 88 357