FLYMO HOVER COMPACT 330
Manual de Usuario

How to Mow
1. For the best results mow the outside edge of the lawn in a clockwise direction first. (H1) 2. Then start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already cut. (H2) 3. For best grass collection always mow in a straight line, do not swing the lawnmower from side to side. Do Not Overload Your Mower Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed drops you may overload your lawnmower which may cause damage. When mowing in long thick grass a first cut with the cutting height set higher will help reduce the load. See Adjusting the Cutting Height.

H

2

1 Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and this may also result in poor collection.

Adjusting the Cutting Height
Always handle the blade with care - sharp edges could cause injury. USE GLOVES. Never use more than 3 Cutting Height Spacers. Spacers must only be fitted between the blade and the fan and NEVER between the blade and the bolt. 1. Remove the blade bolt, and blade as described in Removing the Blade and Fan. 2. For a Lower Cut - Add spacers to a maximum of 3. 3. For a Higher Cut - Take spacers away. 4. Refit the blade as described in Fitting the Blade and Fan.

J

1. To remove the blade bolt, hold the fan firmly and with the spanner provided loosen the blade bolt by turning it anti-clockwise (J). 2. Remove the blade bolt, blade, spacers and fan.(L) 3. Inspect for damage and clean as necessary. � Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. If the blade is cracked or damaged replace it with a new one. Never use a blade bolt if the insulated head is damaged cracked or missing. Fitting the Blade and Fan 1. Ensure the fan is located correctly.(K) 2. Place the spacers onto the fan ensuring the pegs have located into the holes.(K) 3. Place the blade onto the spacers ensuring the pegs have located into the holes on the blade and ensuring the blades is positioned as illustrated in Figure K. 4. Place the blade bolt through the centre hole of the blade. 5. Tighten down clockwise by hand. 6. Hold the fan firmly and tighten the blade bolt with the spanner provided.

Removing and fitting the Blade and Fan Removing the Blade and Fan K blade bolt
blade
fan spacers

Removing, Emptying and Refitting the Grassbox Grassbox Full Indicator (if fitted) (M) L grassbox is full
� � Your lawnmower may be fitted with a grassbox full indicator IMPORTANT The machine must be switched on for the grassbox full indicator to operate When the ball reaches the top of the indicator window, it is time to empty the grassbox. See figure L. When the ball is NOT visible in the indicator window, grass is being collected. See figure L.

1. 2.

grassbox is empty