Replacing the feet with the provided feet
The feet of the provided speaker can be replaced as required.
1 Remove the four feet on the front and rear
part of the bottom panel using a screwdriver.
2 Attach the feet to the specified positions on
the side panel. (Use the screws removed in 1 for attaching.)
Preparation section
÷ Do not install the subwoofer without feet.
Channel space setting (Except for U.K., Europe and Australia)
The space between radio channels has been set to the one that prevails in the area to which the system is shipped. However, if the current channel space setting does not match the setting in the area where the system is to be used, for instance when you move from area 1 or area 2 shown in the following table or vice versa, proper reception of AM/FM broadcasts cannot be expected. In this case, change the channel space setting in accordance with your area by referring to the following table.
Main unit only
1 Select the "TUNER" input.
TUNER/BAND
2 Press the STOP7/TUNING MODE key.
(for more than 5 seconds)
Each press switches the space frequency alternately. 1 FM 50 kHz, AM 9 kHz 2 FM 100 kHz, AM 10 kHz
STOP 7
Area
TUNING MODE
CHANNEL Space Frequency FM: 100 kHz AM: 10 kHz FM: 50 kHz AM: 9 kHz
1 2
USA, Canada and South American countries Other countries