1-3. Board Attachment
. This section is described how to attach the board in PFVHD300. For how to attach it in models other than PFVHD300, refer to the manual supplied for each model. . Insert the board in any blank slot of PFV-HD300. n Do not insert the board in the slot No. 14. The maximum two HKPF-1125s can be attached in the PFV-HD50A. The maximum seven HKPF-1125s can be attached in the PFV-HD300 when the only HFPF-1125 will be used. Front panel 1. Loosen the four screws (with stopper) and detach the front panel. 2. Unscrew the six screws and detach the board supports.
3. Insert the board along the board guide rail.
Board guide rail
Board
Put the component side so that it is viewed from the right side.
4. Insert the board in the slot as far as it will go and close the two board levers in the directions of arrows 1.
1
2
2 PSW3 x 6 1 Board lever 1 PSW3 x 6 Board supports 2 Board lever 1Attachment 2Detachment 1 2
5. Put the supplied label onto the board lever. 6. Attach the board supports. 7. Attach the front panel. n When detaching the board, pull out the board toward you while pushing the two board levers in the directions of arrows 2.
