|
|
|
Usuarios conectados
Actualmente hay 5819 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
MODELS: HD-5000 / HD-5000A
Circuit Adjustment Mode
Most of the adjustments can only be performed using the remote hand unit. Many of the adjustments must be performed in both the 480i and 1080i modes. Video/Color adjustments must be performed in the 480i and 1080i modes, and data must be preset in the 480P (DVD) and VGA modes. Note: Set the Remote Operational Mode to �NetCommandTM�. (Hold the �Power� button and press �1-9-7� in sequence.) This slows the remote�s response and makes adjustments easier. When adjustments are complete, set the Remote to its� original Operational Mode.
A. Activating the Circuit Adjustment Mode
The current signal source determines if the activated Adjustment Mode is 480i or 1080i. 1. 2. 3. 4. Select the signal source (480i or 1080i). Select �Cable/DBS/DTV� remote layer. Press the "MENU" button on a remote hand unit. Press the number buttons "0", "3", "5", "7" in sequence. The screen will change to the Adjustment Mode. Note: Repeat steps 1 and 2 if the circuit adjustment mode does not appear on screen.
CHASSIS MODE ADJ ITEM
V21S 0 1 SCT 42 480i
DATA SIGNAL
ABBREV.
B. Selection of adjustment Functions and Adjustment Items
To select an adjustment item in the circuit adjustment mode, first select the adjustment function that includes the specific adjustment item to be selected. Then select the adjustment item. Refer to the following pages for the listing of adjustment functions and adjustment items. 1. Press the "AUDIO" button on a remote hand unit to select an adjustment function. Each time the button is pressed, the Function changes in the following sequence:
VC JNGL Adjustment Functions
VIDEO ADC
MNTS
AUD
SNTS
2. Press the �VIDEO� button to select a specific Adjustment Item. The Item number increases each time the �VIDEO� button is pressed.
C. Changing Data
After selecting an adjustment Item, use the �ADJUST UP/DOWN� buttons to change data. � Press �ADJUST DOWN� to decrease the data value. � Press �ADJUST UP� to increase the data value.
D. Saving Adjustment Data
Press �ENTER� to save adjustment data in memory. The character display turns red for approximately one second in this step. Note: If the circuit adjustment mode is terminated without pressing �ENTER�, changes in adjustment data are not saved. Page 14
|
|
|
> |
|
