PHILIPS HD4760/00
Manual de Usuario

8 � �

ENGLISH
When the cooking process is finished, you will hear a beep.The cook/reheat light goes out and the keep-warm light starts to burn continuously to indicate that the rice cooker has automatically switched to the keep-warm mode (fig. 6). In the cake baking mode and the steaming mode, the process ends when the rice cooker beeps. In these modes the rice cooker does not switch to the keep-warm mode.

9 Press the COOK/REHEAT button to start the cooking process (fig. 7). The cook/reheat light goes on and the cooking process starts. The display counts down in minutes (10, 9, 8 etc.) during the last 10 minutes of the cooking process. The table below shows the approximate cooking time in each mode.The actual cooking time may vary depending on voltage, room temperature, humidity and amount of water used.
Function Regular Quick Small Amount Steam Cake Casserole Soup Congee Reheat Approximate cooking time Countdown time until (minutes) ready (minutes) 40-50 30-40 40-50 10-60 40-50 45-60 30-240 30-240 23 10 10 10 n.a. (not appplicable) n.a. n.a. n.a. n.a. n.a.

10 Open the lid and stir the rice to loosen it (fig. 8). For the best results, do this just after the rice cooker has switched to keep-warm mode.Then close the lid firmly. Stirring the rice allows excess steam to escape.This will give fluffier rice. 11 Press the OFF button to cancel the cooking process, the preset setting or the keep-warm mode.The cook/reheat light will start to blink (fig. 9). The rice cooker has a backup memory that retains the last selected mode, function and settings in case of a power failure.The cooking process or the timer function will resume within 2 hours after the power supply is restored. Always press the OFF button before you unplug the rice cooker, as otherwise the last selected mode, function and settings will resume when the rice cooker is plugged in again. 12 Unplug the rice cooker from the mains to switch off. Cooking congee 1 Follow steps 1 to 7 in section 'Cooking rice'. Do not exceed the volume indicated in the table for congee cooking, as this may cause the rice cooker to overflow. 2 Press the MENU button to select the congee cooking mode (fig. 10). 3 Press the COOKING TIME button to set the desired cooking time (fig. 11). � � � The default cooking time of 1 hour is displayed. Press the HR and/or MIN buttons to set the desired time.You can set any time between 30 minutes and 4 hours (fig. 12). If you fail to set a cooking time, the default cooking time of 1 hour will apply.

4 Press the COOK/REHEAT button to start the congee cooking process (fig. 7).