� If necessary, you can move the slide switch upwards a little further (fig. 5).This can be helpful when removing smaller slices of bread. � You can interrupt the process of toasting by pressing button STOP (fig. 6). The slide switch is automatically released and the light integrated in button STOP goes off. Reheating bread � To reheat cooled-off toast: - Set the browning selector at the � badge untill you hear a �click� (fig. 7). - Move the slide downwards to switch on. � The toaster will switch off after approximately 30 seconds. Defrosting bread - Set the browning selector to position 7 y (fig. 8). - Move the slide downwards to switch on. Cleaning � Removing crumbs from the toaster: - First remove the mains plug from the wall socket (fig. 9). - Pull out the crumb tray (fig. 10). Do not shake the appliance upside down to remove the crumbs. Cord storage facility - Before use you can adjust the length of the cord, using the hook indicated with an arrow (fig. 11). - After use, the mains cord can be wound up for storage (fig. 11).
Warming-up buns, croissants and crumpets (for type HD2532 only) - Place the warming rack on top of the toaster (fig. 12). - Place the buns or croissants centrally on the rack (fig. 13). Prevent overheating: do not place more than two pieces at the same time. - Set the browning selector between position 1 and position ¬ (fig. 14).The setting must not be higher than position ¬. - Move the slide downwards to switch on. � If you wish to warm-up buns or croissants on both sides, just turn them upside down after the toaster has switched off. Switch on again. (Do not change the setting.) Placing the dust cover (after use) (for type HD 2553 only) - After use, you can place the dust cover on top of the toaster so that it covers button STOP (fig. 15). � Do not place the dust cover on top of the toaster when the appliance is switched on or when it is still hot as this could lead to damage (fig. 16). For telephonenumbers of the Philips Helpdesk, see the �World Wide Guarantee Leaflet�.
