HCD-DX90
This section is extracted from instruction manual.
Step 2: Setting the time
You must set the time before using the timer functions. The clock is on a 24-hour system for the European model and a 12-hour system for other models. The 24-hour system model is used for illustration purposes.
3
Press ENTER.
The minute indication flashes.
4
Press . or > repeatedly to set the minute. Press ENTER.
The clock starts working.
1
� P p
5
Tip
2,4
=
+
3,5
p
If you�ve made a mistake, start over from step 1.
0 ) ( P
To change the time
The previous explanation shows you how to set the time while the power is off. To change the time while the power is on, do the following: 1 Press CLOCK/TIMER SET. 2 Press . or > repeatedly to select SET CLOCK. 3 Press ENTER. 4 Perform steps 2 through 5 above.
Note
1
Press CLOCK/TIMER SET.
The hour indication flashes.
The clock settings are canceled when you disconnect the power cord or if a power failure occurs.
