Changing the transfer speed
The default setting is 57600bps. Depending on the PC in use, transmission errors may occur. In this case, change to a lower serial speed setting, however, the rate of image transfer will be slower.
1 Select [Transfer speed�] in the [Device] menu. 2 Select the desired setting. 3 Click [OK].
2 3
Changing the image size
You can select the size of an image to be captured.
1 Select [Auto save settings...] in the [Capture] menu.
The [Data save settings] dialog box appears.
2 Select the image size from a list of generic sizes. 3 Click [OK].
NOTE: You can also change the size of an image after capturing. ( pg. 42) Note that if an image is enlarged to the size larger than its original, it will take on a mosaic appearance.
2
3
Changing the connecting port
If you connect two or more serial devices to the PC, select the connecting port depending on the camcorder in use.
1 Select [Connecting Port...] in the [Device] menu. 2 Select the desired connecting port. 3 Click [OK].
