|
Usuarios conectados
Actualmente hay 6029 visitantes y 14 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
EN51
SYMPTOM
POSSIBLE CAUSE(S)
� Press DISPLAY for longer than 1 second to make the indications appear ( pg. 13). � The battery pack is running low. � If the LCD monitor is not open over 60 degrees, the EJECT Switch does not function. � The Power Switch is set to �AUTO�. � Certain combinations of modes or effects are not possible to use. � This sometimes occurs when the contrast between the background and the object is great. It is not a defect of the camcorder. � Sunlight is directly entering the lens. This is not a defect of the camcorder. � The light used to illuminate the LCD monitor causes it to be hot. Close the LCD monitor to turn it off or set the Power Switch to �OFF�, and let the unit cool down. � The LCD monitor and the viewfinder are made with highprecision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor or in the viewfinder. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99 %.) � This may occur when the surface or the edge of the LCD monitor is pressed. � Wipe them gently with a soft cloth. Gently wipe in a semicircular motion, as wiping strongly spreads the stain and it won�t come out easily. � Turn the camcorder�s power off, then disconnect the power source. After a few minutes, try turning the power on again. If the error number still appears, consult your nearest JVC dealer. � The dioptre needs to be adjusted ( pg. 10). � The scene being shot is adversely affecting the operation of Auto Focus ( pg. 30). � This is normal while recording in the LP mode. Some noise may be present while recording in the SP mode ( pg. 8). � If you remove the power source from the camcorder while the power is on, all settings and selections are erased. Make sure to turn the camcorder�s power off before disconnecting the power source. � If you have not performed Date/Time Setting ( pg. 7), the date and time are not displayed/recorded correctly. Be sure that Date/Time setting is carried out. � The Lens Cover Warning indicator may blink when the camcorder is used in dark areas, regardless of the position of the lens cover.
OTHER
During recording, the indications do not appear. The tape will not eject.
Some functions are not available.
Vertical white lines appear when shooting a very bright object. Bright, crystal-shaped spots appear in the LCD monitor and the viewfinder. The rear of the LCD monitor is hot.
Coloured bright spots appear all over the LCD monitor or the viewfinder.
The indicators and the picture colour on the LCD monitor are not clear. The LCD monitor, the viewfinder and the lens have become dirty (ex. fingerprints). An error number (i.e. E03) appears.
The image is out of focus.
The picture is blurred in the Quick Review or Retake mode. The date and time displays disappear.
The wrong date and time are displayed/recorded. Even though the lens cover is open, the Lens Cover Warning indicator blinks.
|
|
|
> |
|