Turn off the camcorder. Slide down OPEN/EJECT in the direction of the arrow, then swing the cover open until it locks. The cassette holder opens automatically. Remove the cassette. Press �PUSH HERE� to close the cassette cover. Slide down BATT. RELEASE and remove the battery pack.
Remove.
OPEN/EJECT Switch
Cleaning The Camcorder
1 CLEAN EXTERIOR
Wipe gently with a soft cloth. �Put cloth in diluted mild soap and wring it well to wipe off heavy dirt. Then wipe again with a dry cloth.
2 CLEAN LCD MONITOR
BATT. RELEASE Switch
Wipe gently with the provided cleaning cloth or a commercially available soft cloth. Be careful not to damage the monitor. Close the LCD monitor. Blow it with a blower brush, then wipe gently with lens cleaning paper.
3 CLEAN LENS
4 PULL OUT VIEWFINDER FULLY 5 CLEAN VIEWFINDER
Bottom of viewfinder Blower brush
Slide the cover in the direction of the arrow 1. Insert a lens blower or a soft cloth into the gap at the bottom of the viewfinder and clean the interior of the viewfinder with it 2. Close the cover until it locks in place. Push the viewfinder back in.
1
Gap
6 PUSH VIEWFINDER BACK IN
2
NOTES:
� Avoid using strong cleaning agents such as benzine or alcohol. � Cleaning should be done only after the battery pack has been removed or other power units have been disconnected. � Mould may form if the lens is left dirty. � When using a cleaner or chemically treated cloth refer to the cautions of each product.
