Recording From The Middle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing back the recording previously made (without taking the tape out between recordings), perform this procedure.
O
MENU
START/STOP Button
STOP
REW
FF
PLAY/PAUSE
1 SELECT OPERATION MODE
Turn the Power Dial to �PLAY� while pressing down the lock button located on the dial.
5 START RECORDING
2 PULLMONITOR OUT VIEWFINDER OR OPEN LCD 3 START SEARCH
Turn the Power Dial to any operation mode except �PLAY� and �OFF�, then press START/ STOP. �Start recording from a point prior to the end of the last recording. A few seconds of the end of the last recording will be erased.
Pull out the viewfinder fully or open the LCD monitor to approx. 90° degrees. �The lens cover opens, the power lamp comes on. Press 4/6, then press 2 or 3. Watch in the viewfinder or the LCD monitor for the spot where you want to begin recording.
NOTE:
If you start recording from the end of the previous recording leaving no blank space, there may be situations where a clean transition is not possible.
4 ENGAGE STILL MODE
Once you find the spot at which you want to start recording, press 4/6 to engage the Still mode.