EN How To Attach The Grip Belt
1) Remove the pad and separate the two straps.
7
How To Attach The Strap
1) Thread one end of the strap through the eyelet, then pass the other end through the loop.
2) Thread one end of the strap g through the eyelet, then pass the other end through the loop.
g h
2) Attach the screw to the tripod mounting socket. To tighten the screw firmly, use a coin, etc.
3) Repeat the same procedure to attach the strap h to the other eyelet.
3) Adjust the length with the adjuster.
4) Connect the strap g and h and thread the strap h through the buckle, then adjust the grip. ( pg. 12)
More than 2 cm (13/16�)
5) Attach the pad.
NOTES: � You can use the strap as a shoulder strap by adjusting the length with the adjuster. � Because the screw may cause damage to the camcorder, make sure to attach the screw to the tripod mounting socket when carrying the camcorder. � Use the strap only with this camcorder. � Do not grip the camcorder too firmly when the screw is attached. Doing so may cause damage to the tripod mounting socket.