JVC GR-DVP7A-BK/A-SL/ED/SH
Manual de Usuario

86 EN

TROUBLESHOOTING (cont.)

34. Coloured bright spots appear 34. � The LCD monitor and the 34. all over the LCD monitor or the viewfinder are made with viewfinder. high-precision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor or the viewfinder. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99 %) 35. The indicators and the image 35. � This may occur when the colour on the LCD monitor are surface or the edge of the not clear. LCD monitor is pressed. 36. The cassette will not load properly. 36. � The cassette is in the wrong position. � The battery�s charge is low. 35.

�

� 36. � Set it in the right position. ( pg. 16) � Install a fully charged battery. ( pg. 10, 11) 37. � Set it in the right position. ( pg. 17) 38. � Push in the memory card a few more times. ( pg. 17)

37. The memory card will not load 37. � The memory card is in the properly. wrong position. 38. The memory card cannot be removed from the camcorder. 38. �

39. Picture does not appear on the 39. � The viewfinder is pulled out. 39. � Push the viewfinder back in. LCD monitor. � The LCD monitor�s brightness � Adjust the brightness of the setting is too dark. LCD monitor. ( pg. 13) � If the monitor is tilted upward 180 degrees, open the monitor fully. ( pg. 13) 40. Images on the LCD monitor are jittery. 40. � The speaker volume is too great. � 40. � Turn the speaker volume down. ( pg. 22) 41. � Wipe them gently with soft cloth. Wiping strongly can cause damage. ( pg. 91) 42. � Set �TIME CODE� to �ON�. ( pg. 38, 48, 51) 43. � Check the section of the manual that explains LCD monitor/viewfinder indications. ( pg. 96 � 99)

41. The LCD monitor, the 41. viewfinder and the lens have become dirty (ex. fingerprints). 42. Time code does not appear. 43. An unusual mark appears.

42. � �TIME CODE� is set to �OFF�. 43. �