When removing a tape on which you were recording, or when you resume recording on a tape after playing back the recording previously made (without taking the tape out between recordings), perform this procedure.
LCD monitor
OF REC 5S F
Lock button
Power Dial
S
RECORDING START/STOP Button
PLAY/PAUSE STOP
REW
FF
1 OPEN LCD MONITOR 2 SELECT MODE 3 START SEARCH
Make sure the LCD monitor is open fully. Press down the lock button located on the Power Dial and turn the Power Dial to "PLAY". Press PLAY/PAUSE, then press REW or FF. Watch in the LCD monitor for the spot where you want to begin recording.
5 START RECORDING
NOTE:
Set the Power Dial to �REC� and press RECORDING START/STOP.
�Start recording from a point prior to the end of the last recording. A few seconds of the end of the last recording will be erased.
4 ENGAGE STILL MODE
Once you find the spot at which you want to start recording, press PLAY/PAUSE to engage the Still mode.
If you start recording from the end of the previous recording leaving no blank space, there may be situations where a clean transition is not possible.
