EN
7) Press the Recording Start/Stop Button again to stop recording. The indication stops rotating. NOTES: � After dubbing, set �S/AV INPUT� back to �OFF�. � Analogue signals can be converted to digital signals with this procedure. � It is also possible to dub from another camcorder.
51
1 2 3 4 5 6 7 8 9
Make sure all units are turned off. Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration. Set this camcorder�s VIDEO/MEMORY Switch to �VIDEO�. Set this camcorder�s Power Switch to �PLAY� while pressing down the Lock Button located on the switch. Turn on the video unit�s power. Insert the source cassette in this camcorder. Insert the recording cassette in the video unit. Press 4/9 on this camcorder to start playback of the source cassette. At the point you want to start dubbing, engage the video unit�s Record mode. To pause dubbing, engage the video unit�s Record-Pause mode and press 4/9 on this camcorder. Repeat steps 8 � 10 for additional editing. Stop the video unit and camcorder.
Dubbing To A Video Unit Equipped With A DV IN Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.
10 11
To DV IN/OUT*
Core filter
DV cable (optional)
To DV IN
Video unit equipped with DV connector
NOTES: � It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 11) � If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units. � If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed. � Even though the DV cable is connected correctly, sometimes the image may not appear in step 9. If this occurs, turn off the power and make connections again. � If �Title Impose� ( pg. 49), �Playback Zoom� ( pg. 55) or �Playback Special Effects� ( pg. 56) is attempted or SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV connector. � When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.
