JVC GM-H40L1G/E
Manual de Usuario

Note for VIDEO IN B (RGB/COMPO., DVI-D) terminals Select the correct input for Input B on the main menu (see �INPUT CONFIGURATION� on page 23). � When RGB signals are input to the RGB/COMPO. terminal: Set �INPUT B� to �ANALOG RGB.� � When component signals are input to the RGB/COMPO. terminal: Set �INPUT B� to �COMPONENT.� � When using the DVI-D terminal: Set �INPUT B� to �DVI.� Note for component signals � The monitor is compatible only with Y on sync signals. The monitor is not compatible with composite sync (Cs) and separated sync (HD/VD) signals. Note for computer signals � When a signal other than those listed on page 12 is input, part of the picture may not be displayed or an unnecessary picture may appear. � Any signal other than those listed on page 12 may not be displayed normally although it�s frequency is within the acceptable range. � Depending on the connected equipment, the monitor may not be compatible with composite sync (Cs) or G on sync signals. � When a preset mode signal is input, the signal format is displayed on the screen. For other signals, the horizontal frequency and vertical frequency are displayed. � The DVI-D terminal can accept only No. 3, 6, 7, 8, and No. 13 signals. � When the No. 3 and No. 7 signals are input, set �SAMPLING MODE� to �STD� on the set-up menu (see page 31). � When the No. 4 and No. 8 signals are input, make the following settings: � Set �SAMPLING MODE� to �WIDE� on the set-up menu (see page 31). � Change the aspect ratio to �FULL� (see pages 17 and 21). � Set the video card of the personal computer to �852 x 480� (for No. 4 signal)/�1366 x 768� (for No. 8 signal). � When No. 12 to No. 15 and No. 19 signals are input, thin lines may become obscured because their signal frequencies are higher than the screen resolution. � The adjustment of the screen size and position is the setting common to the No. 10 and No. 18 signals. If you use both signals by switching them, the adjustment of either signal may not be proper.

13

ENGLISH

Note for VIDEO IN A (IN, Y/C IN) terminals When both IN terminal and Y/C IN terminal are used, the input to the Y/C IN terminal has priority.