Drying Rack
The drying rack is useful for drying items you would not necessarily want to tumble dry or that you would normally line dry (for example, sweaters). To use the drying rack Do not remove the lint screen. 1. Open dryer door. 4. Close the door. 5. Select a timed drying cycle and temperature, or an air cycle (see following chart). Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Only temperature setting. 6. You must select a time by pressing MORE TIME or LESS TIME. Reset time as needed to complete drying. Refer to the following table. 7. Press (and hold) HOLD TO START button (about 1 second). NOTE: You must remove rack for normal tumbling. Do not use automatic cycles with the drying rack. This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold. Rack Dry Setting Temp. Time*
A
A. Front edge
2. Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure over the lint screen.
A
Wool Sweaters Block to shape and lay flat on the rack. Stuffed toys or pillows Cotton or polyester fiber filled Stuffed toys or pillows Foam rubber filled
Timed Dry
Low
60
Timed Dry N/A
Low
60
Air Only (no heat) Air Only (no heat)
90
A. Dryer back panel
Sneakers or canvas shoes
N/A
90
3. Put the wet items on top of the rack. Leave space between the items so air can reach all the surfaces. NOTE: Do not allow items to hang over the edge of the rack.
*(Minutes) Reset time to complete drying, if needed.