Attaching LCD Options
You can attach mounting accessories to the LCD display in one of the following two ways:
Caution:
� This unit does not stand stable without the tabletop stands. Use the mounting accesories (not supplied) to install it without the tabletop stands. For details, refer to the instruction manual of the mounting accesories. � When display is installed in the portrait position, left edge should be upper from front view.
1. In the upright position
2. Lay the screen face down
EXIT INPUT MUTING
To avoid damaging the screen face, place the protective sheet on the table to lay the LCD on. The protective sheet was wrapped around the LCD in the original packaging. This device cannot be used or installed without the Tabletop Stand or other mounting accessory. For proper installation it is strongly recommended to use a trained, JVC authorized service person. Failure to follow JVC standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding your warranty. When using mounting accessories, they must be compatible with VESA® Flat Display Mounting Interface Standard FOR 23� TO 30.9� DIAGONAL Flat Displays (Hole Pattern 200 mm x 100 mm). JVC strongly recommends using screws M4 size and 8mm in length. If using screws longer than 8mm, check the depth of the hole. (Recommended Fastern Force: 150 - 170N�cm) JVC recommends using mounting interface that comply with UL1678 standard in North America. When using the mounting accesories, screw the mouting accessories in the rear of the display. Hole Pattern: 200 mm x 100 mm (by using 6 screws)
Screw holes (for using 6 screws)
Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surrounding objects as shown in the diagram to the right.
*
*Ambient temperature should be less than 40 deg C
To avoid falling down
Fasten the LCD display to a wall using a cord or chain which is sufficient to support the weight of the LCD display (approx. 16kg).
Table
Tabletop Stand
Before moving the LCD display, the cord or chain should be removed.
