Changing tuning grid (not available for
all versions) In North and South America, the frequency step between adjacent channels in the MW band is 10 kHz (9 kHz in some areas). Changing the tuning grid will erase all previously stored preset radio stations.
1 2
Tune to your desired radio station (refer to �Tuning to radio stations�). Press PROGRAM. � PROG starts flashing. � The next available preset number is displayed for selection.
To store the radio station to another preset number � Press TITLE -/+ ¡ / � PRESET to select the desired preset number.
1 2
Disconnect the system from the AC power supply (pull out the AC power cord). While holding down TUNER and á on the system, reconnect the system to the AC power supply. � The display will show "GRID 9" or "GRID 10". Notes: � GRID 9 and GRID 10 indicate that the tuning grid is in step of 9 kHz and 10 kHz respectively. � The FM tuning grid also will be changed from 50 kHz to 100 kHz or vice versa.
3
Press PROGRAM again to store the radio station. � PROG disappears.
� Repeat steps 1�3 to store other radio stations. To exit manual preset mode � Press 9 on the system. Notes: � If you attempt to store more than 40 preset radio stations, "FULL" is displayed. � During programming, if no key is pressed within 10 seconds, the system will exit the programme mode automatically.
Tuning to preset radio stations
� Once you�ve programmed the radio stations, press TITLE -/+ ¡ / � PRESET to select the desired preset number. � The preset number, radio frequency, and waveband are displayed.
