|
Usuarios conectados
Actualmente hay 6043 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Clock/Timer
English
2
Press CD 1/2/3, TUNER or TAPE to select the desired source. � �CD1 [or 2, 3] XX:XX" indicates the CD mode is selected. � �TU XX:XX� indicates the Tuner mode is selected. � �TA1 [or 2] XX:XX� indicates the Tape mode is selected.
Activating the timer (for the same preset time and source)
1 2
Press and hold CLOCK�TIMER for more than two seconds. Press CLOCK�TIMER again to store. � The last set timer information is displayed for a few seconds and is shown.
q Before setting timer, make sure the music source has been prepared. CD 1/2/3 � Load the disc(s). TUNER � tune to the desired radio station. TAPE � load the prerecorded tape into tape deck.
Sleep timer setting
The sleep timer enables the system to switch to standby mode automatically at a preset time.
1
3 4 5
Press à or á on the system repeatedly to set the hour for the timer to start. Press à or ë on the system repeatedly to set the minute for the timer to start. Press CLOCK�TIMER to store the timer.
Press SLEEP on the remote control repeatedly to select a preset time. � The selections are as follows (time in minutes): 15 � 30 � 45 � 60 � 90 � 120 � OFF � 15 � � "SLEEP XX" or "OFF" is displayed. "XX" is the
� "TIMER ON" is displayed, followed by the set timer "XX:XX" and the selected source. � remains on the display. q At the preset time, the selected sound source will play. To exit without storing the setting q Press �on the system. Notes: � When the preset time is reached and the selected disc tray is empty, the next available disc will be selected. If all the disc trays are not available,Tuner will be selected automatically. � During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically. Deactivating the timer
2
time in minutes. When you reach the desired length of time, stop pressing the SLEEP button. � is shown, except for "OFF" mode. � The sleep timer is now set. Before the system switches to standby mode, a countdown of 10 seconds is displayed. "SLEEP 10" � "SLEEP 9".... � "SLEEP 1" � "SLEEP"
To check the remaining length of time after sleep timer is activated q Press SLEEP once. To change the preset sleep timer q Press SLEEP again while the remaining sleep timer is shown. � The display will show the next sleep timer options. To deactivate the sleep timer q Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.
1 2
Press and hold CLOCK�TIMER for more than two seconds. Press � on the system to cancel the timer. � "CANCEL" is displayed and the disappears.
26 3139 115 21422
pg 001-030/M355/22-Eng
26
4/17/02, 10:37 AM
|
|
|
> |
|